General Description - GYS Energy 123 Manual De Instrucciones

• EAC conformity mark (Eurasian Economic Commission)
Mise au rebut :
• This product should be disposed of at an appropriate recycling
• Product whose manufacturer is involved in the packaging's
• Recyclable product that falls within waste sorting

GENERAL DESCRIPTION

The chargers ENERGY 123, 124 and 126 are designed to charge lead acid batteries with liquid electrolyte, nominal vol-
tage from 12V, and with capacity according to the following table:
ENERGY 123
ENEGRY 124
ENERGY 126
OPERATING MODE WITH TESTER FUNCTION
When it is not connected to the mains supply, this charger is a battery tester. It lets you know the state of the battery.
The integrated voltmeter informs you:
• <12.3V : battery to be charged
• between 12.3 and 12.6V : middle charge
• >12.6V : charged
CONNECTION IN CHARGER FUNCTION
Preliminary precautions
• For indoor use, with good ventilation.
• Remove the battery caps if there is, and check the level of liquid. If it is not correct, filled up with distilled water.
Clean well the battery terminals.
• Check if the battery capacity and voltage are compatible with your charger.
Connection and disconnection
• Disconnect from the battery all electronic system during the charge (Do not charge the battery when it is connected
to the vehicle as it may damage the vehicle's on-board electronics).
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good electric contact,
respecting the following order.
◦ Connect first the battery terminal not connected to the chassis of the vehicle.
◦ Then connect the other connection to the chassis remote from the battery and any fuel line.
◦ At last, plug in your charger to 230 V 50/60 Hz mains supply.
After charging, disconnected the battery charger from supply mains. Then remove the chassis connection and the
battery connection, in this order.
Control of the charge process
• You should observe a variation of the voltage indicated by the voltmeter. When this voltage is over 14,8 volts, the
battery has reached its full charge state. The charge must then be stopped.
• Do not connect the charger more than 24 hours on a battery.
8
ENERGY 123, 124, 126
facility. Do not dispose of in domestic waste.
recycling process by contributing to a global system of sorting,
collecting and recycling of households' packaging waste.
recommendations
Current
2A DC
3A DC
4A DC
Minimum Maximum
8 Ah 30 Ah
10 Ah 45 Ah
15 Ah 60 Ah
EN