Thermador PA30GLBC Instrucciones De Instalación página 4

Tools Needed
• T-20 Torx head screwdriver or drill
• Protective Work Gloves
Attach the backguard before sliding the appliance into the
final installed position.
1. Depending on model, remove the 2 or 3 stainless Torx
screws in the front face of the included Island Trim. Lift
up to fully remove the Island Trim.
2. Slide the support brackets of the Low Backguard
between the two rangetop chassis back panels.
Page. 3
3. Secure the back with 8 x 1½'' (38 mm) screws
provided.
4. Secure the front of the Low Backguard to the
rangetop with 2 or 3 x ½'' (12.7 mm) screws.
9½" 9½"
(239) (239)