Charging With The Supply Unit - Philips 9000 Serie Manual Del Usuario

14
English
Charging

Charging with the supply unit

Blocked shaving heads
If the shaving heads are blocked, the exclamation
mark lights up orange continuously (Fig. ). The
replacement reminder and the cleaning reminder
flash white alternately and you hear a sound (Fig. ).
In this case, the motor cannot run because the
shaving heads are soiled or damaged.
If the shaving heads are soiled, you have to clean
them. If the shaving heads are damaged, you have
to replace them.
Charge the shaver before you use it for the first
time and when the display indicates that the
battery is almost empty. The battery charge is
indicated by the battery charge percentage shown
on the display.
When you connect the shaver to the wall socket,
you hear a sound.
Charging takes approx. 1 hour. A fully charged
shaver has a shaving time of up to 60 minutes.
Note: You cannot use the appliance while it is
charging.
1 Make sure the appliance is switched off.
2 Put the small plug in the appliance and put the
supply unit in the wall socket (Fig. ).
3 After charging, remove the supply unit from the
wall socket and pull the small plug out of the
appliance.