Tripp-Lite B006-VU4-R El Manual Del Propietario página 6

Hotkey Operation
Change Hotkey
Mode Activation
Command
Change Port OS to
Mac
Change Port OS
to Sun
Change Port OS to
Windows
Turn Beeper On/Off To turn the Beeper sound on or off when performing Hotkey and Setting
Keyboard/Mouse
Reset
Show KVM
Information
Restore Default
Settings
17-10-467-932937.indb 6
(continued)
Initiate Setting Mode by holding down the [Num Lock] key, pressing and
releasing the minus [-] key, and releasing the [Num Lock] key. Once
initiated, press [t] to switch to [Ctrl], [Ctrl]. When set at [Ctrl], [Ctrl],
change the Hotkey Mode Activation Command back to [Scroll Lock], [Scroll
Lock] by holding down the [Num Lock] key, pressing and releasing the
minus [-] key, and then releasing the [Num Lock] key. Once initiated, press
[t] to switch to [Scroll Lock], [Scroll Lock]
When a Mac computer is connected to the KVM, it may be necessary to
change this setting to ensure proper keyboard and mouse functionality.
To change the port OS to Mac, initiate Setting Mode by holding down
the [Num Lock] key, pressing and releasing the minus [-] key, and then
releasing the [Num Lock] key. Once initiated, press [F2].
When a Sun computer is connected to the KVM, it may be necessary to
change this setting to ensure proper keyboard and mouse functionality.
To change the port OS to Sun, initiate Setting Mode by holding down the
[Num Lock] key, pressing and releasing the minus [-] key, and releasing the
[Num Lock] key. Once initiated, press [F3].
By default, each Port OS is set at Windows. To change the port OS to
Windows, initiate Setting Mode by holding down the [Num Lock] key,
pressing and releasing the minus [-] key, and releasing the [Num Lock] key.
Once initiated, press [F10].
Mode commands, initiate Setting Mode by holding down the [Num Lock]
key, pressing and releasing the minus [-] key, and releasing the [Num Lock]
key. Once initiated, press [b].
If the keyboard and mouse are not responding normally, perform a
Keyboard/Mouse Reset: Initiate Setting Mode by holding down the [Num
Lock] key, pressing and releasing the minus [-] key, and then releasing the
[Num Lock] key. Once initiated, press [F5].
This command will display the Hotkey Activation Command, Setting Mode
Activation Command and each port's OS Setting in a Word document
or spreadsheet. To display this information, open a blank document or
spreadsheet. Initiate Setting Mode by holding down the [Num Lock] key,
pressing and releasing the minus [-] key, and releasing the [Num Lock] key.
Once initiated, press [F4].
This command restores the KVM's Hotkey Activation Command, Setting
Mode Activation Command and each port's OS Setting to the default value.
To Restore Default Settings, initiate Setting Mode by holding down the
[Num Lock] key, pressing and releasing the minus [-] key, and releasing the
[Num Lock] key. Once initiated, press [r], [Enter].
6
11/6/2017 9:30:14 AM