Tripp-Lite SmartPro AGSM7715 El Manual Del Propietario página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Battery Cartridge Replacement
Under normal conditions, the original battery cartridges in your UPS will last many years. See
Safety section before replacing battery cartridges. The battery cartridges are designed for hot-
swap replacement (i.e. leaving the UPS in ON mode), but some qualified service personnel
may wish to put the UPS in the OFF mode and disconnect equipment before proceeding.
Procedure
Remove the screws
1
front bezel.
Separate the front bezel
2
front panel. Note: The front bezel will
NOT completely detach from the front
panel, as it is connected to the unit's
LED wiring connection strip. DO NOT
SEVER OR ALTER THIS STRIP IN ANY
WAY.
Remove the screws
3
battery retention bracket
bracket to the left, then out towards
you.
Disconnect the front battery cartridge's
4
connectors
front battery cartridge. Reach into the
unit to pull the rear battery cartridge to
the front, disconnect it's connectors and
remove/recycle the rear battery
cartridge.
Replace the rear battery cartridge and
5
connect its connectors
and red-to-red, then push it all the way
back into the unit. Replace the front
battery cartridge and connect its
connectors black-to-black and red-to-
red.
Replace the battery retention bracket
6
by sliding it in to the left, then back
behind the brace and re-attach the
screws
.
C
Replace the front bezel
7
Replace the screws
8
front bezel in place.
18-11-091-932968.indb 13
which secure the
A
from the
B
that secure the
C
. Slide the
D
and remove/recycle the
E
black-to-black
E
.
B
to secure the
A
1
B
2
3
4
D
13
A
8
7
D
C
6
E
5
12/12/2018 9:58:55 AM

Publicidad

Tabla de contenido
loading

Tabla de contenido