Tripp-Lite SmartPro AGSM7715 El Manual Del Propietario página 5

Mounting (Rack)
2
Secure the shelves
rails permanently using the included
screws and cup washers
• For 3U equipment mounting, place 6
screws total at the front and 4 screws
total at the back.
Warning: Do not attempt to install
your equipment until you have
inserted and tightened the required
screws. The plastic pegs will not
support the weight of your equipment.
3
Attach your equipment's mounting
brackets to the forward mounting holes of
the cabinet using the hardware included
with your equipment. The mounting
bracket "ears" should face forward.
(Some equipment may have pre-installed
or integral mounting brackets.)
4
With the aid of an assistant (if
necessary), lift your equipment and slide
it into the shelves. Attach the equipment
mounting brackets to the forward
mounting rails with user-supplied screws
and washers
user-supplied nuts are also required.)
Tighten all screws securely.
Mounting (Tower)
Mount all modules in an upright, tower position using included base stands (Model:
2-9USTAND). The user must determine the fitness of hardware and procedures before
mounting.
The UPS system is shipped with two sets of plastic feet
and extensions
A
the UPS power module (3U), a battery module and a
second battery module (up to 9U total).
Adjust the feet to a width of 5.25 inches (13.3 cm) for
the UPS power module. Align the feet in your
installation area, approximately 10 inches (26 cm)
apart. Have one or more assistants help you place the
units on their sides in the feet. The control panel of the
UPS should be the UPS upper corner and face outward.
Note: Graphic represents a power module, first and second
battery module (9U) configuration.
18-11-091-932968.indb 5
to the mounting
B
as shown.
C
. (For 3U installation,
D
that can be used to tower mount
B
C
2
3
D
4
5
B
C
B
A
12/12/2018 9:58:47 AM