Tripp-Lite SRCTMTTLBM Guia De Instalacion página 3

Installation
1
Before proceeding with installation, make sure the SRCTMTFRM Frame Kit has been properly
assembled.
Refer to the SRCTMTFRM Installation Guide for more information.
2 Extend the telescopic beam to the approximate desired length, based on the number of
racks you intend to enclose.
Minimum Width: 96 in. / 2444 mm (4 racks per side using standard 24 in. / 600 mm rack width)
Maximum Width: 144 in. / 3662 mm (6 racks per side using standard 24 in. / 600 mm rack width)
Note: Make sure the telescopic beams are extended to equal length on both ends.
3