Step 1
Your Wall Desk is intended to be fastened to wall studs using the included hardware.
å
If you need to drywall hang this unit, purchase a drywall anchor which is rated to support a MINIMUM of
å
80 lbs. Follow the instructions provided with the anchoring hardware.
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
Determine the desired height of the Wall Desk on your wall and subtract 5-5/8". Mark this location on your
å
wall. This will be the bottom edge of the WALL SUPPORT (A).
Locate and mark the wall stud locations on your wall.
å
NOTE: BE SURE THE TWO MARKS ON THE STUDS ARE LEVEL BEFORE DRILLING.
å
Drill a 1/8" hole in your wall at each wall stud location.
å
Fasten the WALL SUPPORT (A) to your wall using two BLACK 2-3/8" FLAT HEAD SCREWS (4) into the
å
exact holes shown.
Page 4
Wall stud
Angled edge
www.sauder.com
A
BLACK 2-3/8" FLAT HEAD SCREW
(2 used in this step)
4
423704