Replacing Battery; To Replace Headlight Bulbs; Interlocks And Relays - Briggs & Stratton TRAPP 42L13G60x8A Manual De Instrucciones

2. Then remove Red cable from both
batteries.

Replacing battery

Caution!
Do not short battery terminals by
allowing a wrench or any other
object to contact both terminals at
the same time. Before connecting
battery, remove metal bracelets,
wristwatches, rings, loose clothes etc.
The positive terminal must be
connected first to prevent sparking
from accidental grounding.
1. Lift hood to raised position.
2. Disconnect black battery cable then red
battery cable and carefully remove battery
from tractor.
3. Install new battery with terminals in same
position as old battery.
4. First connect red battery cable to positive
(+) battery terminal with hex bolt and keps
nut as shown. Tighten securely and cover
terminal with its lid.
5. Connect black grounding cable to negative
(-) battery terminal with remaining hex bolt
and keps nut. Tighten securely .

To replace headlight bulbs

1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.

Interlocks and relays

Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
✔ Check wiring.
111
ENGLISH