Briggs & Stratton TRAPP 42L13G60x8A Manual De Instrucciones página 119

Problem
1. Obstruction in clutch
Mower blades will
not rotate
2. Worn/damaged mower drive
3. Mower belt out of engine
Poor grass discharge
1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air pressure
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
8. Mower drive belt worn.
9. Blades improperly installed.
10. Improper blades used.
11. Clogged mower deck vent holes
Headlight(s) not
1. Switch is "OFF".
working
2. Bulb(s) or lamp(s) burned out
(if so equipped)
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
Battery will not
1. Bad battery cell(s).
charge
2. Poor cable connections.
3. Faulty regulator (if so equipped).
4. Faulty alternator.
1. Throttle control has not been
Engine "backfires"
when turning engine
"OFF"
Probable cause
mechanism.
belt.
pulley.
trash under mower.
from buildup of grass, leaves,
and trash around mandrels.
placed between medium and
fast speed position before
shutting engine off.
117
ENGLISH
Solution
1. Remove obstruction.
2. Replace mower drive belt.
3. Install belt on engine pulley.
1. Place throttle control in "FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before mowing.
4. Level mower deck.
5. Check tires for proper air pressure.
6. Replace/sharpen blade. Tighten blade
bolt.
7. Clean underside of mower housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge down.
10. Replace with blades listed in this manual.
11. Clean around mandrels to open vent
holes.
1. Turn switch "ON".
2. Replace bulb(s) or lamp(s).
3. Check/replace light switch.
4. Check wiring and connections.
5. Replace fuse.
1. Replace battery.
2. Check/clean all connections.
3. Replace regulator.
4. Replace alternator.
1. Move throttle control between medium
and fast speed position before shutting
engine off.