Engine Oil; Cylinder(S); Other - Briggs & Stratton TRAPP 42L13G60x8A Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Never store equipment with gasoline in
the tank. Fully drain gas tank and, if
necessary, let engine run until it shuts off
due to lack of fuel.
To avoid permanent damage, never use
engine or carburetor cleaner products in
the fuel tank.
Use fresh fuel next season.
Note: Fuel stabilizer is an acceptable
alternative in minimizing the formation of
fuel gum deposits during storage. Add
stabilizer to gasoline in fuel tank or
storage container. Always follow the mix
ratio found on stabilizer container. Run
engine at least 10 minutes after adding
stabilizer to allow the stabilizer to reach
the carburetor. Do not drain the gas tank
and carburetor if using fuel stabilizer.

Engine oil

Drain oil (with engine warm) and replace
with clean engine oil. (See "Engine" in the
Maintenance section of this manual).

Cylinder(s)

1. Remove spark plug(s).
2. Pour 30 ml of oil through spark plug
hole(s) into cylinder(s).
3. Turn ignition key to "START" position for a
few seconds to distribute oil.
4. Replace with new spark plug(s).

Other

Do not store gasoline from one season to
another.
Replace your gasoline can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
If possible, store your tractor indoors and
cover it to give protection from dust and
dirt.
Cover your tractor with a suitable
protective cover that does not retain
moisture. Do not use plastic. Plastic
cannot breathe which allows
condensation to form and will cause your
tractor to rust.
Important: Never cover your tractor while
engine and exhaust areas are still warm.
114
ENGLISH

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Trapp 42l15g60x8aTrapp 42l18g60x8a

Tabla de contenido