Names And Functions Of Parts (Main Unit) - Teac W-1200 Manual Del Usuario

A
J
A Cassette compartment
B RETURN TO ZERO button
Press to return the tape to the "
stop (page 17).
C COUNTER RESET buttons
Press to reset the tape counter to "
D
Remote control signal receiver
When operating the remote control, point it towards here.
E DIMMER button
Press to change the brightness of the display.
F REPEAT button
This allows repeat playback of a selected section of the tape
(page 18).
G PARALLEL REC (parallel recording) button
This button starts recording to both TAPE 1 and TAPE 2 simulta-
neously (page 24).
H Display
This shows tape counters, level meters, etc (page 13).
I DUB START (dubbing start) button
This button is used when copying the contents of a tape from
TAPE 1 to TAPE 2 at normal speed (page 23).
o Dubbing from TAPE 2 to TAPE 1 is not possible.
o Dubbing at high speed is not possible.
10

Names and functions of parts (main unit)

B C D E F G H I
K L M
" counter position and
".
C B
O L
J POWER button
Press to turn the unit on and off.
K PITCH CONTROL knob
This adjusts the playback pitch. This does not function when
recording or dubbing (page 17).
L Cassette tape operation buttons
RECORD (0) button
Use when recording.
Press to start recording standby (page 18).
PAUSE button
Press to pause playback/recording.
Press again to resume playback/recording.
REC MUTE (record muting) button
Use to create a silence of about four seconds when recording
or in recording standby (page 20).
Rewind/fast-forward (m/,) buttons
Use these buttons to rewind/fast-forward.
Stop (8) button
Press to stop playback, recording, rewinding or fast-forwarding.
PLAY (y) button
Press to start cassette tape playback.
Press when playback/recording is paused to resume playback/
recording.
EJECT (-) button
Press to open the cassette compartment when the tape is
stopped.
A
P Q