Teac W-1200 Manual Del Usuario página 30

No or very little sound is output.
e Confirm connections with the amplifier.
e Confirm connections with the speakers and other devices.
e Confirm that operation of the connected device is correct.
e Confirm that speaker cable ¥ and ^ are not shorted.
There is noise.
e Place the unit as far away as possible from TVs, microwave
ovens and other devices that have strong magnetism.
Cassette compartment does not close.
e It will not close if the cassette tape is not properly loaded.
Reinsert the cassette correctly.
Sound quality is poor.
e Clean the heads (page 8).
Playback speed seems somewhat fast or slow.
e Check the pitch control setting (page 17).
Recording is not possible.
e If the erasure prevention tabs of the loaded cassette tape
have been broken off, stick a piece of adhesive tape over the
hole(s).
e Check the recording level setting (page 19).
e Confirm connections with the amplifier and the source
device.
e Confirm that the amplifier selector is set correctly.
Timer-controlled playback/recording does not start.
e For timer playback, set the TIMER switch to PLAY.
e For timer recording, set the TIMER switch to REC.
e Press the POWER button on this unit to turn it on.
e After setting timer playback/recording, turn the power off
from the timer. (When the timer turns the power on, the
W-1200 will operate.)
30
Troubleshooting (continued)
This unit uses a microprocessor, so noise and other external inter-
ference could cause it to stop functioning properly. If this occurs,
unplug the power cord, wait for a while, and then turn the power
back on to restart operations.