Indel B DRINK 20 PLUS Instrucciones Para El Uso página 8

ENGLISH
ELECTRICAL CONNECTION AND EARTHING
Before connecting the plug to the mains, make sure the mains voltage corresponds to that shown on the
rating plate (located inside the minibar) and that the socket has a normal earthed system as required
by safety regulations for electrical systems. The electrical socket must also be able to support the
maximum power loading of the appliance indicated on the plate itself.
WARNING!
If the socket is not fitted with an earthed system or if multiple sockets or adapters are used, the manufacturer
shall not be liable for any injuries to persons or damage to property and/or the minibar itself.
WARNING!
The user must always be able to access the plug.
USE
The minibar will start to work as soon it is plugged in, unless the switch behind the lamp is an intermediate
"0" position (see figure 02).
This switch has three different positions:
• in position P1 the average inside temperature is about 5°C;
• in position 0 the refrigerator is off.
• in position P2 the average temperature is about 7°C.
Upon delivery of the minibar, the switch is in position P1 and the unit cools correctly: if you wish to increase
the inside temperature, the switch must be moved to position P2. The inside temperature and defrosting
cycles are automatically controlled by the electronic circuit of the minibar, guaranteeing a constant
temperature and preventing a build up of ice in the food products stored.
In relation to the minibar models with wooden furniture, the wheels on the bushes at the bottom of the
furniture, may be screwed down (see Fig 03).
In the niche versions, the door can be hooked onto the leaf of the cabinet housing through the drawing line
which allows for simultaneous opening (dragging system). If the door opens in the opposite direction
from the leaf of the cabinet, proceed as follows:
• unscrew the screws which fasten the plate A to the structure of the refrigerator;
• take the bush with the pin B and the open bush C out from their plates and exchange their position;
• take the pin D out from its seat and fit it into the opposite one;
• fit the top pin into the hole of the front panel E opposite its previous position;
• put the plate A back using the relevant screws (see figure 04).
APPLYING THE DRAFT
(see figure 05)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to the
door of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
- screw the part A onto the door of the Minibar;
- open the door of the Minibar by 90°;
- screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit it into the
part A so it can work as a sliding guide.
8
DRINK PLUS
DRKP.02_02-07-2014