Pull - Sauder Executive Desk Manual Del Usuario

Step 19
1
å Pull the DRAWER FRONT BRACKETS (7G) apart and slide them into the grooves in the DRAWER SIDES (D53 and D59 ). You may
need to gently tap them in with a hammer.
å NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH" for easy identifi cation.
å Fasten the DRAWER FRONT (L) to the DRAWER FRONT BRACKETS ( 7G). Use two BLACK 9/16" LARGE HEAD SCREWS (1S).
2
U n fi
n i s h
s u r
f a c
e
D53
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D707) into the
å
grooves in the DRAWER SIDES (D53 and D59) and
DRAWER FRONT (L).
Page 24
L
D53
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
e d
D707
D59
L
VIEW THE T-SLOT BOX VIDEO
Push down
7G
D59
Groove
3
D109
D53
D59
Fasten the DRAWER BACK (D109 ) to the DRAWER SIDES (D53
å
and D59). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other small drawer.
å
402159
BLACK 9/16" LARGE HEAD SCREW
(4 used in this step)
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(8 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
www.sauder.com/services
1S