Sauder Executive Desk Manual Del Usuario página 27

Step 22
Insert a GROMMET (10P) and GROMMET CAP (1P) into the hole in the TOP INSERT (F2)
å
To insert a large drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the
å
unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way in,
then it will slide in and out easier.
To insert the small drawers into your unit, tip the front of the drawer down and drop the rollers on the drawer behind
å
the rollers on the unit. Lift the front of the drawer up and slide it into the unit. Repeat this step to insert the
KEYBOARD SHELF (T).
NOTE: The DRAWER FRONTS may need adjustments. To adjust the DRAWER FRONTS, loosen the SCREWS in the
å
DRAWER FRONT BRACKETS. Make adjustments and tighten the SCREWS.
For long-term care and maintenance of your unit, you may touch up the edges with the TOUCH-UP PEN (9M).
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
9M
www.sauder.com/services
1P
10P
100 lbs.
F2
35 lbs.
35 lbs.
402159
25 lbs.
T
15 lbs.
15 lbs.
35 lbs.
Page 27