Vertilux VTi CELTIC RF Manual De Programación página 6

Setting intermediate limits (optional)
4
Up to optional intermediate limits can be programmed between the upper and lower limit. Press
up down button
and hold the or
without any stop at the intermediate limits.
1. Move the shade approximately
desired intermediate limit position and stop it.
programming button
Press and hold the
on the back of the remote until the motor
(Openning Program).
2. Move the shade up or down and stop it at the
desired intermediate limit position and then press
and hold the programming button
"jogs" again (Closing Program). The intermediate
limit is now set.
*Repeat the same steps for any additional intermediate limit.
Erasing an intermediate limit
The upper limit cannot be erased or modified once it has been set.
1. Move the shade to the limit you want to erase.
2. Press and hold the
on the back of the remote for approximately
until the motor "jogs"
erased.
Readjusting the lower or an intermediate limit
1. Move the shade to the limit you want to readjust.
Press and hold the programming button
on the back of the remote until the motor "jogs".
2. Move the shade to the new desired position and
press stop. Then press and hold the
button located on the back of the remote until the
motor "jogs". The limit has been readjusted.
2 s
for if you want the motor to reach the
4" from the
located
"jogs"
until the motor
programming button located
7 s
twice. The limit has been
located
programming
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
~4"
INTERMEDIATE
LIMIT
upper lower
or limit
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
vertilux.com
5