Vertilux VTi CELTIC RF Manual De Programación página 8

Deleting a single motor or channel
This is a convenient feature when there has been a programming mistake and it is required to
delete the programming from a single channel. Also if you want to delete a programmed motor in
a single channel, turn off the power supply of all motors previously programmed in this channel
except the one you want to delete and follow this procedure.
1. Select the desired channel using the
channel selector button, and press and hold the
stop button for about
2. Press and hold the
2 s until the motor "jogs". The selected
about
channel has been deleted. Motors previously
linked to this channel are not linked anymore.
Deleting all channels
This is needed when there has been a programming mistake and the remote control needs to be reset.
1.
Press and hold the
until the motor "jogs".
2.
Press and hold the
about 7 s. The motor will "jog", and in a few
seconds the motor will
previous programming on the remote control has
been deleted.
Resetting the motor to factory default
1. Press and hold the programming button
located on the head of the motor for about
hold the button until the motor
"jogs"
then two more times.
All previous programming on the motor has been
deleted.
5 s until the motor "jogs".
programming button for
stop button 5 s
for about
programming button
for
"jog" two more times. All
7 s
"jogs" once and
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
and
STOP
BUTTON
PROGRAMMING
BUTTON
STOP
BUTTON
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
vertilux.com
7