Loading The Dispenser; Startup And Operation - Omnifilter WD1 Instrucciones De Instalación Y Funcionamiento

4

LOADING THE DISPENSER

Follow these guidelines for loading the dispenser.
• Make sure the heater and chiller are turned off
• The top of the bottle should be cleaned before installing.
• If the water bottle has a cap, remove it before placing it on the
dispenser. It may have a flexible plug. Leave the plug in place.
E
N • Tip the bottle carefully so the spout of the bottle is centered on the
bottle support.
G
L
I
S
H
Figure 3 - Loading the Dispenser
START UP AND OPERATION
Severe burn hazard. Children should not use this
product unless supervised by a responsible adult.
Operating the WD1
1. Press the hot and cold water dispenser levers until water runs
from both faucets and air is released into the bottle.
POWER
HEATING
COOLING
Heating Switch
Cooling Switch
Figure 4 - WDI Control Panel
Power Indicator
Heating Indicator
Cooling Indicator
Heating Switch
Cooling Switch
2. Plug in the dispenser.
3. Push the HEATING and COOLING power switches located on the
front panel to turn them on. The heating and cooling indicators
should light. The lights will turn off when the water reaches
temperature.
NOTE: The compressor start will be delayed by up to 3 minutes
after the cooling power switch is pushed.
4. Allow 30 minutes for water to reach hot and cold temperatures.
Operating the WD2
Key Functions
AM
PM
HEATING
COOLING
SETTING
TIMING
Figure 5 - WD2 Control Panel
HEATING
During operation this will start and stop the heater. It is pushed
momentarily to start the heater, and held down for 1 second to shut it
off.
When changing the temperature setpoint, this will increase the
setting.
When setting time, this key scrolls hours forward.
COOLING
During operation this will start and stop the chiller. It is pushed
momentarily to start the chiller, and held down for 1 second to
shut it off.
When changing the temperature setpoint, this will decrease the
setting.
When setting time, this key scrolls minutes forward.
SETTING
During normal operation, this will cycle through hot water setpoint,
cold water setpoint, time adjust and normal operation.
When this is pushed and timing mode is on, this will cycle through
start time, stop time and timing mode operation.
°C
°F
C/F