Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Instructions
Model: VMF
Thank you for choosing Sanus Systems wall mount furniture. This product is designed to mount VESA
75/100 LCD televisions up to 50 pounds onto a vertical wall. It allows you to effortlessly tilt your new
television up to 15° up or down without the use of tools. Check carefully to make sure there are no missing
or defective parts. Never use defective parts. Improper installation may cause damage or serious injury. If
you do not understand these directions, or have any doubts about the safety of the installation, please call a
qualified contractor or contact Sanus at 800.359.5520 or www.sanus.com. We can quickly assist you with in-
stallation questions and missing or damaged parts. Replacement parts for Sanus products purchased through
authorized dealers will be shipped directly to you.
Note: The hardware provided is for wood stud walls only. If you are uncertain about the nature of your
installation please consult a local contractor.
Required Tools: Drill with 3/16" bit, Phillips screw driver
Supplied Parts:
Mounting the Wall Plate: The Wall Plate (a) MUST be mounted to a wood stud. Use a high quality
stud sensor to locate a stud. It is a good idea to verify where the stud is located with an awl or thin nail. Use
the Wall Plate as a template to mark the two hole locations on the wall. Make sure these holes are aligned
vertically and centered over the stud. Pre-drill the two holes using a 3/16" drill bit. Attach the Wall Plate to
the wall using the two Wall Mount Screws (g) as shown in Diagram 1. Tighten the Wall Mount Screws until
they protrude 1/4 inch from the wall. You will firmly tighten the Wall Mount Screws during final assembly.
g
for
VISIONMOUNT
(1) Wall Plate - a
(1) TV Mount Plate - b
(2) Glide - c
(1) Carriage Bolt and Washer - d, e
(1) Knob - f
(2) Wall Mount Screw - g
Diagram 1
LCD
Wall
TM
(4) M4 Bolt - h
Mount
(1) Allen Key - i
a
Publicidad
