In Case Of Fire - Johnson Controls ANSUL CHECKFIRE 110 Guia Del Propietario

IN CASE OF FIRE: Manual Actuation
1) Safely bring equipment to complete stop, set brake and
shut off engine.
2) Break visual seal and open guard door.
3) Push the red "PUSH To Activate / Alarm When Lit" button.
4) Release circuit immediately activates the connected fire
suppression system (if included, pressure switch activates
auxiliary operation). See Note below.
5) Safely exit equipment and stand-by with supplemental
firefighting equipment.
6) Optional manual actuation: Pull ring pin and strike red
button on electric or pneumatic manual actuator.
Note: The red "PUSH To Activate / Alarm When Lit" LED and
sounder remain steady-on for 10 sec. during initiation (release)
of fire suppression system. Post release: "PUSH To Activate/
Alarm When Lit" and Release LEDs and sounder continue to
pulse 1 x 10 sec. If safe to re-enter equipment, push "DELAY/
Reset/Silence" button to silence sounder for two hours.
Fill-In System Information (as installed)
Electric or Pneumatic Manual Actuator Location(s):
PUSH RED BUTTON FOR
IMMEDIATE ACTIVATION
PAGE 2
OPEN
GUARD DOOR
009241