Dantherm DRC1 Manual De Instrucciones página 12

EN
Alarms continued
High pressure fail
Service alarm
Press for 5 seconds
to enter installer
menu setup
Alarms priority
12
Dehumidifier has stopped because of High Pressure detection .
Fail can not be dismissed from Remote panel .
It is not allowed to enter menu setup for modification of set points values .
The Service icon will be shown when it is time for servicing the dehumidifier .
The service alarm does not affect the operation of dehumidifier .
To dismiss/reset service alarm:
- Press right for 5 seconds to enter the installer menu .
- Press DOWN/UP to navigate to service icon .
- Press RIGHT/LEFT to change setpoint from 0 to desired service interval .
- Confirm service interval by pressing enter .
HP High priority
LP
SEnS
Abt
Low priority
Abrh
When more than one alarm is active the list above
shows the priority of the alarms.