Desoutter D53-5 S X/Y CANopen Manual Del Usuario página 12

6159922530_06
Original instructions.
© COPYRIGHT 2016, GEORGES
RENAULT 44818 ST HERBLAIN FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is designed for holding power tools
within the specified load / torque capacity.
No other use permitted.
For professional use only.
INSTALLATION
● To learn how to configure the arm
as a positioning arm by using CVI
CONFIG software and CVI3 Vision
controller, refer to the user manual
6159923060 available at http://
resourcecenter.desouttertools.com.
Installing the torque arm
A
See page 4.
● Before you start the installation, measure the
applicable position of the torque arm for your
working area.
● Fasten the torque arm base with 3 screws
(not supplied) on a perfectly horizontal bench.
Tighten the screws until the torque arm is
properly seated.
B
See page 4.
● Select the applicable holes on the arm for
optimal operation within your working area.
C
See page 4.
● Choose the tool holder orientation.
D
See page 4.
● Fasten the tool holder at the end of the
horizontal arm with the screws.
● Tighten the screws with the recommended
torque.
● Attach the tool to the tool holder on the
recommended tool clamp area with
the screws. Tighten the screws to the
recommended torque.
For more information about correct tool clamp
area and recommended torque, see the
applicable tool Product Instruction or contact your
local Desoutter representative.
E
See page 4.
● Set the balancer. Turn the wheel on the
balancer to get the optimum
● resistance (depending on the tool). The tool
can at this time be connected to the power
supply.
Installing the digital top encoder
F
See page 5.
● Put the encoder with coupling on the shaft at
the top of the vertical arm.
G
See page 5.
● Carefully tighten the clamping flange with the
screw.
H
See page 5.
● Fasten the protection over the encoder with
the screws.
I
See page 6.
● Pass the transucer cable into the cable
fastener.
Calibration
J
See page 7.
● Stick the arrow labels to indicate the encoder
reset position.
Connection to controller
K
See page 7.
● Close the folded arm to fully protracted
position.
● Using the T-junction connector, connect the
top encoder on @20, the middle encoder on
@21 and the CVI3 on the last plug.
● Use the cable adaptor (6159176630) to
connect the CVI3 to the T-junction connector.
● Refer to the CVI3 user manual to set-up the
installation.
Length and offset for CVI3 configuration
wizard
L
See page 9.
12 / 28
English
05/2019