Uline H-623 Guia De Inicio Rapido

H-623
PUSHER TENSIONER
• Before operating the tool, review the enclosed
General Hand Tools and Strapping Safety booklet.
Only trained personnel should operate Uline
tensioner hand tools.
• Only use strap recommended for the tool. H-623
is recommended for 3/8" x .015 through 1⁄" x .031
gauge steel.
• Review instructions and safety material on a
regular basis.
1. Pull strapping from cart and bring around load. Push
seal on with flat side of the seal facing outside of
strap. (See Figure 1)
Figure 1
2. Slide end of strap through bottom of seal and fold
over to form a "hook". (See Figure 2)
PAGE 1 OF 3
1-800-295-5510
uline.com
SAFETY
OPERATION
3. Push the top strap through the rack and flapper slot
Figure 3
4. Hold tensioner above package and move lever
Figure 2
5. Seal the pusher seal with an appropriate heavy duty
6. With the seal secured, tilt the entire tool forward over
Pour le français, consulter la page 3.
CAUTION! Dangerous breakage may occur
due to excessive tensioning, possibly resulting
in severe injury or death. Tension strap in
moderation.
CAUTION! Keep fingers away from areas that
can pinch or cut. These areas are primarily
located at the front of the tool.
WARNING! Unsafe use may result in blindness,
severe laceration, amputation or death.
and under the gripper dog with the seal against the
front of the tool. Ensure the strap is flush with inside
edge of tensioner. (See Figure 3)
back and forth to tension.
sealer.
the seal and back again approximately three times
to bend and break the strap.
Para Español, vea página 2.
0424 IH-623