Kohler K-13711 Guia De Inicio Rapido página 3

Key
Flange
Nut
Reducer
Screw
Long Pipe
Short Pipe
Body
Medium Pipe
Elbow
1. Install The Supply Stop
Apply thread sealant to the male threads of all pipes.
Thread the short pipe into the water supply fitting. Tighten with
a clean strap wrench.
Slide the flange over the short pipe.
Thread the body onto the short pipe. Tighten with a clean strap
wrench.
Thread the medium pipe into the outlet end of the body and
tighten with a clean strap wrench so that the open end of the
elbow is pointing straight up. Thread the elbow onto the medium
pipe.
Thread the reducer on one end of the long pipe. Thread the other
end of the pipe into the elbow. Tighten with a clean strap wrench.
Slip a coupling nut over a bullnose tailpiece (not supplied).
Thread the tailpiece into the reducer. Tighten the coupling nut to
the faucet inlet.
Insert the volume control key (provided) and turn it clockwise to
ensure that the stop is closed.
Turn on the water supply.
Check for leaks before the supply stop and tighten as needed.
Open the supply stop. Check for leaks after the supply stop and
tighten as needed.
Secure the flange against the wall by tightening the setscrew.
Kohler Co. 3 1042870-2-A