Kohler SPUN GLASS VESSELS K-2276 Instrucciones De Instalación página 5

Ocultar thumbs Ver también para SPUN GLASS VESSELS K-2276:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect the faucet supply lines.
Connect the drain assembly.
Open the faucet valves, and check for leakage.
Clean up with a non-abrasive cleaner.
ABOVE-COUNTER INSTALLATION
Cut out the template along the inside of the template
cutout line labeled "Above-Counter Cut-Out".
Position the template on the countertop.
NOTE: Wall-mount faucet installations: Be sure to
provide sufficient spout overhang into the lavatory basin.
See the roughing-in notes for minimum spout length
information.
NOTE: Countertop faucet installations: Pay special
attention to the spout and handle fit clearance when
locating the faucet, as noted below.
Countertop faucet installations: Use the template to
locate the faucet spout hole centerline on the countertop.
This centerline is recommended to provide adequate
clearance between the edge of the lavatory and the spout.
Check for adequate clearance between the backsplash,
faucet spout and handles, and lavatory. We recommend
clearance of at least 1" (2.5cm) between:
S
the installed lavatory and the faucet spout;
S
the installed lavatory and the end of the faucet
handles;
S
the faucet spout and handles, and the backsplash.
Refer to the faucet installation instructions for required
clearance, and mark the preferred faucet hole locations.
Trace the template on the countertop.
Kohler Co., Kohler, WI U.S.A.
Nut
Backsplash
Spout
Centerline
Cut-out
Line
5
Gasket
Nut
Gasket
Fig. #12
1" (2.5cm)
Minimum
Clearance
Outside Edge
of Lavatory
Fig. #13
1010430-2-
A

Publicidad

Tabla de contenido
loading

Tabla de contenido