Kohler SPUN GLASS VESSELS K-2276 Instrucciones De Instalación página 6

Cut out the opening by carefully following the pencil line.
CAUTION: Risk of personal injury or product
damage. Large lavatories are very heavy. Get help
lifting the lavatory into place.
Temporarily position the lavatory in the countertop cutout
so the "Kohler" logo is visible. The logo is located inside
the basin, near the rim, and should be positioned near the
faucet.
Verify proper clearance between the lavatory, faucet, and
backsplash.
Remove the lavatory from the countertop cutout, and
return it to its protective carton. Do not stand or store the
lavatory on the drain surface.
Drill the faucet holes.
Install the faucet to the countertop according to the
manufacturer's instructions.
Install the drain to the lavatory according to the installation
instructions included with the drain. Apply a generous
amount of clear silicone sealant when you install the drain.
For tile, wood, or other porous materials, apply waterproof
sealer around the cutout area of the countertop surface.
Follow all manufacturer's instructions and warnings.
Allow the sealer to dry before proceeding.
Use a 50/50 mixture of isopropyl alcohol and water to
clean the countertop surface around the cutout area.
Wipe dry with a clean cloth.
NOTE: Install the adhesive seal when the temperature is
at least 50 F (10 C). The preferred temperature range to
apply the adhesive seal is 70 F (21 C) to 100 F (37 C).
Loosely apply the adhesive seal (included) around the
entire countertop cutout so it is alongside the cutout hole.
Adjust the placement of the seal before removing the
backing material. Cut off any excess seal material.
Carefully remove the adhesive seal backing material.
CAUTION: Risk of personal injury or product
damage. Large lavatories are very heavy. Get help
lifting the lavatory into place.
Note the location of the "Kohler" logo. The lavatory should
be installed so the logo is visible after installation.
Carefully position the lavatory in the cutout, and press
down firmly.
A
1010430-2-
Adhesive
Seal
"Kohler" Logo
6
Fig. #14
Fig. #15
Fig. #16
Kohler Co., Kohler, WI U.S.A.