Uline H-2058 Manual Del Usuario página 3

Figure 4
Figure 5
Figure 6
PAGE 3 OF 18
ASSEMBLY CONTINUED
3. Insert drawer tracks into inside of desk top, aligning
front and back bolt holes. Drawer slides must face
inward. Use four large bolts and four large nuts to
assemble each drawer track to the desk top.
(See Figure 4)
CABINET ASSEMBLY
1. Attach front channel with two large bolts.
(See Figure 5)
2. Attach side panel with six large bolts and six large
nuts. Lip must face towards desk top. (See Figure 6)
3. Repeat for other side panel and back panel.
4. Install middle shelf at desired height with four large
nuts and four large bolts. Lip must face towards front
of desk.
NOTE: Lip should face the bottom of desk.
NOTE: Hole must be to the left of center.
NOTE: Wait to install top bolts.
0221 IH-2058