Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso página 11

Memorizing additional transmitters in
Table [E]
Mode II
1 Press and hold down the desired key on
the new transmitter (New TX) until you
hear a beep (after about 5 seconds) then
release it
Within 5 seconds, press and hold down
2
for approx. 5 seconds a previously
memorized key on a transmitter (old TX)
until you hear 2 short beeps, then release
the key
Within 3 seconds, press again the same
3
key on the previously memorized
transmitter (old TX) as many times as the
number corresponding to the desired
command: 1 = Step-By-Step; 2 = Open;
3 = Close; 4 = Stop
4 After approx. 3 seconds you will hear a
number of beeps corresponding to the
selected command
Within 2 seconds, press again the
5
desired key on the new transmitter (new
TX) to confirm the programming
The 3 final beeps signal that the new transmitter has been correctly memorized.
If the memory is full (30 transmitters), 6 beeps will signal that the memory is not
capable of memorizing any additional transmitters.
Example
New TX
5s
Old TX
5s
Old TX
X1...X4
X1...X4
New TX
English – 9