Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso página 4

The RC1 receiver must be connected between the power supply line (elec-
trical mains) and the motor which is to be controlled, as shown in figure 4.
WARNING: The electrical systems must be set up by qualified and
experienced personnel in compliance with current legislation.
Can be separated, the RC2 box must be positioned where it is inac-
cessible to the general public. Said box does not guarantee protection
against access to those parts of the system which are live.
If the RC1 receiver is installed outdoors, bear in mind that the cable
holders are only waterproof for round cables with a diameter of 6.5 to
8.5 mm.
01. Make sure there is no voltage anywhere in the electrical circuits.
02. Open the container of RC1 by removing the "cable cap" as shown in
the figure below.
03. Strip the cable coming from the power supply line and the motor cable
about 1,5 cm and then the single wires approx. 5 mm.
04. Thread the two cables through the designated holes in the "cable cap".
05. Pull the card a few centimetres out.
06. Connect the conductors to the terminals as shown in figure 8, observ-
ing the diagram in figure 13.
07. Fold the cables as shown in figure 9.
08. Push the card inside the container, make sure that the stripped length
of the cable is fully inside the container, then slide the "cap" until the
container closes completely.
09. The RC1 receiver does not require mounting, it can be fitted directly in
the shutter/awning box, the adhesive tape supplied can be used for
this. To avoid the risk of water leaks it should be positioned with the
cables towards the bottom.
WARNING: Do not perforate the RC1 container.
10. The STX1 transmitter has a support in order that it can be mounted, to a
2 – English
INSTALLATION
— STEP 3 —