Mhouse RT3N Instrucciones Y Advertencias Para La Instalación Y El Uso página 14

4 Wait for the motor to finish the manoeuvre
(when it stops in the limit switch position)
and after a few seconds press key n to
stop the time count
The 3 final beeps signal that the new working time has been correctly memo-
rized. If the user wishes to reset the factory time of 150 seconds, at point 3 s/he
must press key n until s/he hears the first of 3 beeps indicating programming has
taken place.
Deleting the Receiver Memory
There may be cases when the RC1 receiver memory has to be deleted.
The memory can be deleted:
– using a non-memorised transmitter starting from point A.
– using a previously memorised transmitter starting the procedure from point
N. 1.
• Follow the procedure pressing the keys as shown if the transmitter has been
memorised in Mode I,
• Follow the procedure pressing the same key only, but only if it has been
previously memorised, if the transmitter has been memorised in Mode II.
The following items may be erased:
– Transmitters only, proceeding up to step 4
– All the data (transmitters and working time), completing the procedure up
to step 5.
Table [H] Deleting the memory
Ë
A
With the receiver not
powered, remove the
jumper from the board
(after clearing the
memory, the jumper
must be reinstalled)
12 – English
Example