Function Keys - Mesko MS 8146 Manual De Uso

18. DO NOT strike, DO NOT shake and DO NOT drop the scales.
19. Stand still on the scales while the measurement is being taken.
20. Do not use for commercial or medical purposes.
21. It is recommended that you weigh yourself at the same time each day.
22. The measurements given by the scales can be misleading if you weigh yourself after
intense exercise, during a strict diet or if you are dehydrated.
23. Children under 10 years of age and the elderly may use only the weight measurement
option. The results of measurement options (amount of water, fat or muscle) can be
misleading for people over 70 years of age and people who practise bodybuilding.
24. The device is not intended for pregnant women, people undergoing dialysis, people
with heart pacemakers and other medical implants.
25. If your measurements differ from the norm, consult a physician.
DESCRIPTION OF THE DEVICE (Fig. A)
1.LCD display
2.Glass platform

FUNCTION KEYS:

▲
- up button
SET - on button/parameter change button
ERROR MESSAGES
Lo- low battery, replace the battery
CHANGING WEIGHT UNITS
You can change the units that the weight is displayed in using the switch found under the scales, next to the battery container or under
the cover of the container. Available units: kilograms (kg) and pounds (lb).
BATTERY REPLACEMENT (Fig. B)
Before use remove the isolating layer from the battery contact plate. Note the polarity.
1. Open the battery cover at the bottom of the scales. Remove the old battery.
2. Insert the new battery by sliding one end of the battery into the contact plate and pressing the other side in. Close the
cover.
WEIGHING
STEP 1. Place the scales on a hard and flat surface (avoid carpets and soft surfaces).
STEP 2. Gently step on the scales. Stand on the scales evenly distributing your weight and do not move until your weight reading
shown on the display stops changing and gets blocked.
SETTING MEASUREMENT PARAMETERS (Fig. C)
STEP 1. Place the scales on a hard and flat surface (avoid carpets and soft surfaces).
STEP 2. Press the SET button. An option to set the user code will appear.
▲
STEP 3. Use the and
STEP 4. Press SET to confirm.
Repeat steps 3 to 4 to set the age (2), gender (3), and height (4). After approximately 7 seconds from the last press of the SET button
the scales will switch to the weighing and measuring mode.
WEIGHING WITH MEASUREMENT (Fig. D)
STEP 1. Press the SET button. The last user's parameters will appear. If you want to change the user or parameters use the
▼
buttons.
STEP 2. Gently step on the scales with bare feet. Both feet should touch the measurement plates. Stand on the scales evenly
distributing your weight and do not move until your weight reading shown on the display stops changing (3) and the measurement sign:
oooo appears.
Next a sequence of fat, water, bone, muscle, calorie and BMI index measurements results will appear. They will be repeated three
3.Function keys
4.Measurement plates
▼
- down button
Err1kg- maximum load exceeded
▼
buttons to choose a user code (1).
Err2% - error
▲
and