Voice Message - LG HOM-BOT VR6480 Manual Del Proprietário

If a voice message is announced after Smart Diagnosis, refer to the following table to take proper actions.

Voice message

Roboking smart diagnosis will be started. Please
step away and clear around 1 meter around the home
station.
Smart diagnosis can start when it is being charged.
Please dock Roboking to the home station to charge.
No defect found during diagnosis.
Diagnosis mode cannot be operated due to a low
battery. Please try again after the battery is charged.
Please check if the dust bin is installed with the filter.
Charging cannot be done due to a problem in infrared
sensor.
Charging cannot be done due to a problem in
ultrasonic sensor.
Charging cannot be done due to a problem in the cliff
detection sensors on the bottom. Please clean the
sensors.
Please wipe the lower camera sensor on the right
bottom of the Roboking.
Please wipe the obstacle detecting sensor window on
the left and right side of the Roboking.
A problem has been found on the Gyro Sensor.
Please check for dirt on the left wheel.
Please check for dirt on the right wheel.
A problem has been found on the left wheel sensor.
A problem has been found on the right wheel sensor.
Please check the brushes for obstructions.
A problem has been found in the suction motor.
A problem has been found in the acceleration sensor.
In order to listen to the smart diagnosis result again,
please press the charging button. To stop, please press
the stop button.
Smart diagnosis mode will be turned off.
Smart Diagnosis mode cannot be operated with mop
plate being attached. Please try again after removing it.
Smart diagnosis has failed to operate. Please try it
again after turning off and on the main power switch on
the back of the Roboking.
SMART DIAGNOSIS
Measures (for reference)
Clear any object within a 1 m radius around Home
Station, and stay back until the diagnosis is complete.
Move Robot cleaner to the Home Station to recharge it.
Try the Smart Diagnosis again after recharging the
battery.
Open the Dust Bin Cover and examine the bin.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Clean the three Cliff Sensors on the bottom at the front
of the unit.
Clean the lens of Camera Sensor on the bottom-right.
Clean the lens of the Obstacle Sensors on both the left
and right hand sides.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Check for foreign materials on the left wheel.
Check for foreign materials on the right wheel.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Check for any foreign material stuck in the Brush.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
Run Smart Diagnosis again and, if the same message is
announced, contact an LG Electronics service center.
If you need to repeat the diagnosis result, press
the 'Home' button, or press '
diagnosis.
Please try smart diagnosis again after turning the main
power switch off and on from the back of Roboking. If
the problem continues, please contact LG Electronics
customer care.
Run Smart Diagnosis again after removing the Mop
Plate.
Turn the main power switch OFF and then ON again
to resume the diagnosis. Do NOT touch the robot or
disturb its operation until the diagnosis is complete.
' button to finish the
31