Klarstein Big Daddy Manual Del Usuario página 13

INSTALLATION
Location
When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated. Avoid locating your unit near a heat source, e.g.
cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly. This unit is not designed for use in a garage or outdoor installation. Do not
drape the unit with any covering.
When installing the unit, ensure that 20 cm of free space is left at both sides, 15 cm at
the rear and 20 cm at the top of the unit. This will allow cold air to circulate around the
wine cooler and improve the efficiency of the cooling process. The door can be opened
to the right or the left, depending on what better suits the location. Please ensure there is
adequate space for the door to fully open.
Reversing the Door Swing
1
Start by removing the bracket from the
bottom of the refrigerator.Unscrew the
two screws from the bottom bracket.
Remove the foot from opposite side.
2
Put the pieces aside.
EN
13