To Series Skipper - Series Giro - Series Pop Remote Controls; Setting The First Remote Control; Automatic Disabling Of The First Remote Control Setting Function; Setting Of Additional Remote Controls - Cherubini A510073 Manual De Instrucciones

PROGRAMMING TO SERIES SKIPPER - SERIES GIRO -
SERIES POP REMOTE CONTROLS

SETTING THE FIRST REMOTE CONTROL

This operation can only be performed when the receiver is new, or
after a total delete of the memory. The operation can be performed
in two ways:
T1: First remote control to be set
+
A B
T1 short
+
A B
GB
T1 short
B B
T1 short T1 (2 sec) long
B
T1 short (2 sec)
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
Every time you connect the control unit you have 3 hours to store
the first remote control. After this time, the ability to store the
remote control is disabled. To reset the timer of the function you
have to disconnect and reconnect the control unit.

SETTING OF ADDITIONAL REMOTE CONTROLS

Up to 15 remote controls can be set.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
long
Tn short
20
B B
Tn short Tx (2 sec) long