Operating Modes; Mode 1D (Duplicate Load); To Skipper / Pop Series Remote Controls; To Giro Series Remote Controls - Cherubini A510073 Manual De Instrucciones

OPERATING MODES

This Dimmer allows you to configure and control the two outputs with
two different modes:
• 1D a duplicate load (factory setting).
• 2L two independent loads.
To change mode, see page 28.

MODE 1D (duplicate load)

This mode allows you to control both Dimmer outputs together.
Skipper / POP series remote controls
- + +
A
B
1 2
DIM+ 1/2
Button A (up) turns on and
increases the brightness
GB
of outputs 1 and 2.
1 2
ON/OFF 1/2 DIM- 1/2
Button B (stop) turns Button C (down) turns on
outputs 1 and 2 on and decreases the
and off. brightness of outputs 1 and 2.
Giro series remote controls
UP
DIM+ 1/2
Rotate in the UP
direction to turn on and
increase the brightness
of outputs 1 and 2.
+ -
1 2
24
- +
STOP
1 2 1
ON/OFF 1/2
The STOP button turns
outputs 1 and 2 on
and off.
+ -
DOWN
2 1 2
DIM- 1/2
Rotate in the DOWN
direction to turn on and
decrease the brightness
of outputs 1 and 2.