Remote Control Memory Clearing; Full Memory Clearing - Cherubini A510073 Manual De Instrucciones

REMOTE CONTROL MEMORY CLEARING

It is possible to delete singly all the memorized remote controls. When
the last one is deleted the receiver initial condition is restored. The
same applies to the single channels of a multichannel remote control:
just select the channel to cancel.
A
+
A B
short
Tn
This sequence deletes the remote control from all the associated
receivers.
A
+
A B
short
Tn
This sequence deletes the remote control from a single receiver.
Tn: Remote control to be cleared.
B
short Tn (2 sec) long
Tn
short (2 sec)
Tn

FULL MEMORY CLEARING

The full memory clearing can be performed in two ways:
1) WITH THE REMOTE CONTROL
+
A B
short
Tn
2) WITH THE SET BUTTON
Use this option only in case of emergency or when no working remote
control is available. Use the SET button on the device to clear the
memory.
The procedure sequence is as follows:
1) Disconnect the power from the receiver, for example at the main
breaker switch, and wait at least 5 seconds.
2) Reconnect the power to the receiver holding down the SET
long
button; the Led will blinking briefly.
21
+
A B
B
short Tn (4 sec)
Tn
long
GB