Gb Programming From Another Remote Control; Single Channel Memory Clearing - Cherubini A510073 Manual De Instrucciones

PROGRAMMING FROM ANOTHER REMOTE CONTROL
The A530058 remote control may be set from another remote control
that has already been programmed.
• Press the A and B buttons at the same time.
• The Led lights on with a short blinking.
• Then press the B and C buttons at the same time.
• The Led lights on again with a short blinking.
• Then, press the desired button on the A530058 remote control for at
least 2 seconds.
• The programming Led responds with a long blinking.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
short
Tn
short Tx (2 sec)
Tn

SINGLE CHANNEL MEMORY CLEARING

It is possible to delete each memorized channel individually by
selecting the channel to be deleted during the last step of the
following sequence. To delete all channels, repeat the sequence as
many times as necessary.
Tn: Already programmed remote control
+
A B
short
Tn
long
23
A
short
Tx (2 sec)
Tn
long
GB