Publicidad
• The pulsate rotates for
8 seconds to detect the
laundry load,
• Then the Waster Level and
the amount of Detergent
to be used will be shown
and water will be supplied.
Close the lid
• Water will be
• When the wash
supplied for 2
minutes after the
start of the wash
to supplement the
water the laundry
has absorbed.
Finish
• If water is already in the tub,
or putting wet laundry into the
tub before starting will increase
the Water Level.
• With lightweight bulky loads,
program ends, the
Water Level can be set low.
buzzer will ring for
• Changes to Water Temperature
10 seconds before
(Hot/Cold) and wash level are
the Power goes off
automatically.
possible during operation. (refer
to page 14)
• When setting the Water Level
manually, do not set to Medium
to prevent damage to laundry.
• Washing with Hot water may
damage the laundry (Water is
set to cold automatically). Ensure
that the load is under 2 kg.
• In order to avoid damage to
laundry, the spin cycle may
appear slow. This also avoids
wrinkles and clothing may
still contain some water. T his
is normal
• When static pressure
of water is more than 2
kgf./cm².
Caution & Note
17
Load
Recommend
Less than 12 kg.
Less than 2 kg.
Less than 2 kg.
Less than 12 kg.
Less than 12 kg.
Publicidad
