Publicidad
4
S
afety Information
Read carefully and thoroughly through this booklet as it contains important safety information
that will protect the user from unexpected dangers and prevent potential damages to the product.
This booklet is divided into 2 parts : Warning and Caution.
: This is a warning sign specifying user's applications which might
: This is a sign specifying 'Strictly Forbidden' applications.
WARNING
CAUTION
WATER
HEATER
SAFETY
PROPER
INSTALLATION
be dangerous.
: Failure to comply with the instructions under this sign may
result in major physical injuries or death.
: Failure to comply with the instructions under this sign may
result in minor physical injuries or damages to the product.
WARNING
• Under certain conditions hydrogen gas may be produced in a water heater that
has not been used for two weeks or more. Hydrogen gas can be explosive under
these circumstances. If the Hot water has not been used for two weeks or more,
prevent the possibility of damage or injury by turning on all Hot water faucets
and allowing them to run for several minutes. Do this before using any electrical
appliance which is connected to the Hot water system. This simple procedure will
allow any built-up hydrogen gas to escape. Since the gas is flammable, do not
smoke or use an open flame or appliance during this process.
CAUTION
• The base opening must not be obstructed by carpeting when the washing machine
is installed on a carpeted floor.
• Install or store where it will not be exposed to temperatures below freezing or
exposed to the weather.
If the product is exposed to such conditions, electric shock, fire, break
down or deformation may occur
• Properly ground washer to conform with all governing codes and ordinances.
Follow details in Installation Instructions
If not grounded properly, break down and leakage of electricity may occur,
which may cause electric shock
• Must be positioned so that the plug is accessible.
If the plug is placed between the wall and the machine, it may get damaged,
possibly causing fire or electric shock.
• Make sure the plug is completely pushed into the outlet.
Failure to do so may cause electric shock and fire due to overheating.
Publicidad
