Publicidad
30
C
onnecting Drain Hose
Before connecting drain hose, check your Drain Hose model and choose the correct instructions.
Pump Model
1
Fit the end of the drain hose to the outlet of the drain pump and tighten the clamp.
2
Put the other end of the drain hose over standpipe or wash tub.
NOTE
• To Prevent siphoning, the drain hose should not extend more than 50 mm from the end of the hose guide
• The discharge height should be approximately 0.9 ∼1.2 m from the floor.
• The hanging down drain hose might cause poor drainage.
Non-Pump Model
1
Before connecting
Ensure that the hose clip is set as
indicated here.
2
Connect the elbow hose
Push the elbow hose toward the body
of the washing machine.
3
Place the Drain Hose
To change the direction of hose, pull put
the elbow hose and change the direction
Repeat Step 2.
Hose
guide
within 50 mm.
0.9 ∼1.2 m
Drain hose
Clip
Drain hose
Publicidad
