Troubleshooting - BLACK&DECKER MOUSE MS800 Manual De Instrucciones

• Push the other end of the contour sanding piece until it clicks into place.
• To remove the contour sanding piece, push it forward then pull the rear end out of
the contour holder (fig. 7).
fitting a Sanding Sheet Onto a Contour Sanding Piece (fig. 8)
• Align the sanding sheet with the contour sanding piece.
• Press the sanding sheet onto the contour sanding piece, making
sure that the sanding sheet follows the shape of the profile.
Dust Extraction (fig. 9)
To Empty Dust Canister:
• The dust canister should be emptied after every 10 minutes of sanding.
• While holding the sander, grasp the dust collection canister and pull off of the sander.
• Remove the canister door and gently shake or tap the canister and door to empty.
• Re-attach the door and firmly push the canister back onto the sander.
CAUTION: Respiratory hazard. Never operate this tool for wood sanding unless
the dust canister is in place. Sanding dust exhaust may create a breathing hazard.
wARNING: fire hazard. Collected sanding dust from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-ignite in sander dust canister or elsewhere and
cause fire. To reduce risk, empty canister frequently and strictly follow sander manual and
coating manufacturer's instructions.
wARNING: fire hazard. When working on metal surfaces, do not use the dust canister
or a vacuum cleaner because sparks are generated. Wear safety glasses and a dust
mask. Due to the danger of fire, do not use your sander to sand magnesium surfaces. Do
not use for wet sanding.
Problem
• Unit will not start.
• Dust is not
being collected.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Mouse
A variety of
Note: Use only sandpaper with holes in the same configuration as on the base of the

TROUBLESHOOTING

Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
• Sandpaper holes do not align. • Use Mouse
MAINTENANCE
ACCESSORIES
®
accessories are available at extra cost. Listings per retailer may vary.
• Plug tool into a working outlet.
• Replace circuit fuse.
(If the product repeatedly causes
the circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
• Have cord or switch replaced at
Black & Decker Service Center or
Authorized Servicer.
appropriate hole configuration.
A
8
Possible Solution
®
sandpaper with the