Troubleshooting Guide - MIRKA DEROS 325 Serie Instrucciones De Manejo

Fit and tighten the new backing pad with washers.
3.
Remove the pad wrench.
4.
Pad saver
Mirka's pad savers are designed to protect the backing pad from wear and tear, when sanding aggressively and continuously
with net products. These cost effective pad savers, placed between the backing pad and the sanding disc, should be
changed regularly. The pad savers prolong the life of the backing pad.
https://www.mirka.com/accessories/pad-savers/
Replacing the brake seal
NOTE! Too much vacuum in your dust extraction system may cause the brake seal to malfunction.
Remove the backing pad as described above.
1.
2. Pull the old brake seal out of its groove.
Fit the new brake seal in the groove.
3.
Fit the backing pad as described above.
4.
5. Check the brake seal function. By changing the number of washers between the spindle and backing pad, the
effect of the brake seal can be adjusted.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.

Troubleshooting guide

Symptom
The sander LED (right) flashes
between red and green.
No light from Sander LED (right)
when switched on.
The sander LED (right) is red and the
sander slows down to 4,000 rpm
when sanding.
The sander LED (right) is red and
rpm is slightly reduced.
Brake seal does not work.
The sander has stopped and LED
(right) is red.
Possible cause
Connected to a mains outlet with
wrong voltage.
Power cord not properly attached to
the sander or to the mains socket.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
Worn out brake seal or damaged
spindle bearing.
The tool is in safety mode due to high
temperature.
Mirka® DEROS & 325X, 350X, 550X, 625X, 650X, 680X & 5650X
Solution
Connect the sander to a mains outlet
that correspond with the nominal
voltage of the tool.
Connect it properly.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
Check and replace brake seal or
spindle bearing if necessary.
Wait until the tool has cooled down.
en (original)
17