Operation - Klarstein 10032022 Manual Del Usuario

Installation
Fix two feet on the bottom of the heater by screws.

OPERATION

1 Ensure that the Temperature Control Knob is at "Max" position. Also, make sure
the power switch is at "OFF" position. Plug the power cord into a suitable electrical
outlet.
2 Switch "ON" the heater.
3 Then adjust the temperature control knob to set the room temperature. According to
the personal needs, you can turn the temperature control knob in a clock-wise or
anti-clockwise direction to increase or decrease the room temperature.
4 When the room temperature reaches the pre-set temperature the power will cut
out and the heating indicators light will be "OFF" at the same time. The power
will resume when the room temperature drops at least 3ºC lower than the pre-set
temperature.
5 Anti-Frost mode: It will keep the surrounding temperature above freezing point to
avoid the pipe breakage by ice.
EN
15