Safety Information; Safety Precautions; Selecting The Location - OHAUS Explorer EX125D Manual Del Usuario

Ocultar thumbs Ver también para Explorer EX125D:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8

1. SAFETY INFORMATION

WARNING
CAUTION
Note

Safety Precautions

CAUTION: Read all safety warnings before installing, making connections, or servicing this equipment.
Failure to comply with these warnings could result in personal injury and/or property damage. Retain all
instructions for future reference.
Verify that the local AC power supply voltage is within the input voltage range printed on the AC adapter's ratings label.
Only connect the AC adapter to a compatible grounded socket.
Position the instrument such that the AC adapter can be easily disconnected from the socket.
Position the power cord so that it does not pose a potential obstacle or tripping hazard.
Operate the equipment only under ambient conditions specified in the user instructions.
Do not operate the equipment in hazardous or explosive environments.
Disconnect the equipment from mains power before cleaning or servicing.
Service should only be performed by authorized personnel.
Safety precautions for the Ionizer:
WARNING: ELECTRICAL SHOCK HAZARD
AVOID TOUCHING THE ELECTRODE PINS WHILE THE IONIZER IS TURNED ON.
Intended Use
Use the instrument exclusively for weighing determination as described in the operating instructions. Any other type of use
and operation beyond the limits of technical specifications without written consent from OHAUS, is considered as not intended.
This instrument complies with current industry standards and the recognized safety regulations; however, it can constitute a
hazard in use.
If the instrument is not used according to these operating instructions, the intended protection of the instrument may be
compromised and OHAUS assumes no liability.
2. INSTALLATION

2.1 Selecting the location

The location must be sturdy, flat and level. Avoid locations with excessive air current, vibrations, heat sources or rapid
temperature changes. Allow sufficient space around the instrument.
For a hazardous situation with medium risk, possibly resulting in injuries or death if not avoided.
For a hazardous situation with low risk, resulting in damage to the device or the property or in loss
of data, or injuries if not avoided.
For useful information about the product
General Hazard
Electric Shock Hazard
EN-1

Publicidad

Tabla de contenido
loading

Tabla de contenido