Tabla de contenido
Publicidad
S19-120FM
Supplies Required
• Pipe sealant
• Piping to 1" NPT water supply inlet
• Adequate supply pipe supports
• Minimum 4" (102 mm) drain to accommodate 30
gallons (115 liters) per minute discharge for shower
waste
• (2) Ceiling fasteners (holes in cover plate are Ø 1/4")
• Sign-mounting hardware
Local codes may require the installation of a backflow
prevention valve to complete proper installation. Backflow
prevention valves are not included with the fixture and may
be supplied by the contractor or purchased from Bradley
Corporation.
Install drench shower
1. Rough-in the necessary ceiling cutouts as shown.
2. Connect the drench shower piping as shown on page 4.
3. Apply pipe sealant to all male-threaded pipe joints.
4. The bottom edge of the showerhead should be 7'-0"
(2134 mm) from the floor.
5. Assemble the showerhead components (Item 6) as
shown on page 4.
Connect water supply
NOTICE! Do not rely on Bradley's Drench Shower to
support supply piping.
1. Connect water supply piping to 1" NPT inlet on
unit (piping supplied by installer). Provide adequate
supports (supplied by installer) for supply pipe using
pipe hangers or other means.
2. Thread the showerhead assembly onto the elbow
(Item 3). The showerhead shell will be held in place by
the springs.
3. Mount the safety sign to the wall using sign-mounting
hardware supplied by installer.
4. Open water supply lines. Test for leaks and adequate
water flow.
Ceiling
Tile
Showerhead
Shell
Showerhead
Assembly
4
Spring
Bracket
Spring
Ring
4/8/2019
Ø 5"
(127mm)
1-7/8"
(48mm)
11-1/8"
(283mm)
Specify ceiling
height
4-1/2" to 6"
(114mm to
Ø 5-7/8"
152mm)
(149mm)
9" (229mm)
Bradley • 215-148FM Rev. R; ECO 19-05-003
Installation
2"
(51mm)
2"
(51mm)
Ø 5/16" (8mm)
(2) places
Ø 3-1/4"
(83mm)
4"
(102mm)
minimum
8-1/2"
(216mm)
minimum
False ceiling
maximum
thickness
2" (51mm)
Publicidad
Tabla de contenido
