American Standard Studio-S 4803100 Instrucciones De Instalación página 2

2
MAKE WATER SUPPLY CONNECTIONS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall
supplies. Connection on fitting supplies are 3/8"
compression. Connect left supply (Marked with a Red
Stripe) to Hot and right supply (Marked with Blue Stripe)
to Cold wall supply. Use adjustable wrench to tighten
connections. Do not over tighten.
• Faucet supplies are 21" long from faucet base.
• Note: If additional supply length is required, installer
must purchase additional parts separately.
• Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
3
CONNECT SPRAY HOSE AND INSTALL WEIGHTS
• With PULL-OUT SPRAY (1) seated in FAUCET (2),
install WEIGHT (3) onto HOSE (4) using SCREW (5).
Locate the WEIGHT (3) two feet (2') from the underside
of the sink deck. Tighten SCREWS (5) firmly.
• Make sure SEAL WASHER (7) is installed in COUPLING
NUT (6). Connect threaded end of HOSE (4) to
SPRAY HOSE COUPLING NUT (6) from fitting. Use
wrench to tighten.
4
CHECK CONNECTIONS FOR LEAKS
• Move HANDLE (1) down into "off" position.
• Turn on water supplies and check connections
for leaks.
CHECK CONNECTIONS
1
FOR LEAKS
1
1
- 2 -
HOT
COLD
2
24"
5
3
M985010 (3/19)
2
6
7
4