NORAUTO PREMIUM MF450 Manual Del Usuario página 54

OPERATION
Warning:
Do not leave engine running without jump starter or battery is firmly connected!!
Do not reverse polarity!!
!!There is no reverse or short circuit protection at bypass Mode!!
6- Using Under GLOW mode
In cold weather, the glow plugs in most diesel vehicles will be
first energized to heat up the engine chamber before the engine
start, as indicated by the GLOW sign on dashboard. The process
needs current of 40-60Amp and takes about 4-6 seconds.
In this situation, after the jump starter is fully recharged and
connected, press GLOW button, and then turn on ignition.
Note:GLOW is inactived under BYPASS mode.
7- WORKING CYCLE
Allow sufficient cooling time between two working sessions, failing to do so may cause damage to
the jump starter.
MAX OPERATIONS IN A ROW: 5 TIMES
MIN INTERVAL BETWEEN TWO SESSION: 15MINUTES
5. Put positive lead to battery terminal together
with positive clamp.
Remove positive clamps after positive lead is
fastened to battery terminal.
53