Charger Safety; Technical Features - Rapid BGX300 Manual De Instrucciones

• Charge only at ambient
temperature between 10°C and
40°C.
Charge only using the charger
provided with the tool.
• The battery must be removed
from the appliance before it is
scrapped
• The appliance must be
disconnected from the supply
mains when removing the
battery

CHARGER SAFETY:

• The charger is double insulated;
therefore no earth wire is
required. Always check that the
mains voltage corresponds to
the voltage on the rating plate.
• The charger is intended for
indoor use only.
• Use your charger only to charge
the battery in the tool with which
it was supplied. Other batteries
could burst, causing personal
injury and damage.
• Do not expose the charger to
water.
• Do not open the charger.
• Replace the charger if the wire
is damaged.
• Appliance is only to be used
with the power supply unit
provided with the appliance

TECHNICAL FEATURES:

• Specifications:
1 – Tool support
2 – Nozzle
3 – On/off switch
4 – Tool LED light
5 – Trigger
6 – Socket
7 – Battery unlocking button.
8 – Battery
9 – Plug
10 – Charger
11 – Charger LED
• Tool:
Power rating: 30 W
Battery life: ≈ 1 hour
• Battery:
Voltage: 7,4 V
Capacity: 2600 mAh
Time of charging: < 4 hours
• Charger:
Input: 100-240V 50-60Hz
Output: 8,4 V cc
Intensity: 1000 mA
• Glue: Rapid Ø12 mm
OPERATING INSTRUCTIONS
OF TOOL:
• Removal and connection of
the battery (8): To remove the
battery (8), press the unlocking
buttons (7) and slide the battery
out of the machine. To connect
the battery; slide it in the other
direction until the connection
clicks.
• Stand the tool upright on his
support (1) and the battery (8).
Never put the tool flat on a table.
• Start-up: switch the "on/off
switch" (3) on "I" (on). The green
LED (4) light come on.
• Leave the tool warming up
several minutes.
• Feed glue sticks in to the rear of
the tool.
5