Homak HS40221120 Guía De Utilización Y Directivas De Funcionamiento página 3

Step 1
While the safe door is open, locate the screws
around the perimiter of the door. Use a phillips-
head screwdriver to remove all screws and care-
fully remove the panel from the safe door. Once
the panel is removed store it in a safe location so
that it does not get damaged.
Step 2
Once the door panel is removed from the safe
door, the locking mechanism will become access-
able to a locksmith.
RE-INSTALLING THE DOOR PANEL:
The door panel can be re-inserted by placing it
back into the safe door framing. Replace all screws
making sure not to over-tighten. Over tightening
the screws could result in a crack or fracture in the
door panel.
SHELF INSTALLATION:
When installing the shelves, fi rst locate the small
plastic bag containing the (16) shelf
support clips. Push each clip into place, fl at side up
fi rst then pinch bottom side into the guide strips on
the side walls inside the safe. Make sure to count
down the number of holes in the guide strip
so that each shelf is level and properly supported.
Step 1 Step 2
*NOT INCLUDED IN ALL SAFE MODELS*
PLASTIC BARREL REST INSTALLATION (OPTIONAL):
The safe also comes with an optional plastic barrel rest and mounting bar.
The barrel rest mounting bar comes with a velcro backing so it can be easily mounted
against the side wall to custom fi t gun barrels of different lengths. After the barrel rest
mounting bar has been attached, the barrel rests can then slide into place. Barrel rests can
be moved or adjusted at any time to better fi t your safe.
- 3 -